Follow along with the video or complete the steps below to clean your CrossWave® Pet Pro - Please follow steps in order
Run Cleaning Cycle
- Place machine on storage tray
- Pour water into the rinse funnel, filling up to the max line
- Turn on your machine by pressing the Hard Floor button
- Recline your machine backwards while in the storage tray. Let the machine run for 10 to 15 seconds until all the water is picked up
- Unplug the cord from the outlet
- If any moisture is left over in the tray from cleaning, wipe it dry with a paper towel or cloth
Clean Brush Roll & Foot
- Remove the brush roll window by grabbing the front and pulling up
- Pull out the brush roll by grabbing the tab and pulling up
- Put the brush roll upright onto the Brush Roll Drying Tray to let it dry
- To reinsert the brush roll, please reference our Cleaning Brush Roll video
- Then lock the pull tab into place by pressing downward
- Reinsert the brush roll window by lining up the tabs with the edges of the foot
- Push the brush roll window back into place until you hear a click
Wash Dirty Water Tank
- To remove, grab the handle in front of the dirty water tank and press down on the release button
- Grasp the top of the tank and pull up to remove it
- Now pull out the strainer, place the debris in a waste basket, and rinse under running water
- Empty the dirty water into a sink, then rinse your tank
Cleaning Filter
- Remove the filter from the top of the tank by pulling up
- Hand wash the filter and screen using warm water
- Then rinse the float, located on the bottom of the dirty water bin’s top
- If the inside area where the dirty water tank sits is dirty, wipe it clean with a rag or towel
Reassembly
- Leave the parts out to dry before reassembling
- Once dry, place the vacuum filter back into dirty water tank top
- Then place the strainer in the dirty water tank
- Now, replace the top of the dirty water tank
- To place the tank back on the machine, insert the bottom first at an angle and push it into place until you hear a click